CP30544
Customer Options

C/D Up to two drives may be daisy chained together utilizing the 40 pin Task File connector. The maximum cable length is 18 inches. In order to install more than one drive, it is necessary to set a jumper option. The C/D jumper is used to determine whether the drive is master (drive C) or slave (drive D). The drive is configured as a master (drive C) when jumpered and as a slave drive (drive D) when not jumpered.

DSP & SS This pair of jumpers determines the signals on pin 39 of the interface connector.

Jumper DSP SS		Action
		-Spindle synchronization signal disabled on pin 39
X		-Activity LED signal available on pin 39
		-Spindle synchronization signal enabled on pin 39
	X	-Activity LED signal disabled from pin 39
		-Pin 39 floating

Jumper
Block A	E2
Block A	E3
Block A	E4
Block A	E5
Block A	E6
Block A	E7
Block A	E8
Block B	ATA/ISA

Function
ATA/CAM	Non- CAM
OUT	IN
OUT	IN
OUT	IN
IN	OUT
IN	OUT
IN	OUT
IN	OUT
IN	OUT

CMOS Drive Parameters
Cylinders	1023
Heads	16
Sectors	63
Precomp	0
Landing Zone	1023

J4
1	+12V
2	Ground
3	Ground
4	+5V

J6
1	+5 V
2	+12V
3	Ground