CP30204
Customer Options

The C/D jumper is used to determine whether the drive is a master (drive C) or slave (drive D). The drive is configured as a master (drive C) when jumpered and as a slave drive (drive D) when not jumpered.
DSP & SS:This pair of jumpers determines the signals on pin 39 of the interface connector.

Jumper		Action
DSP	SS
X		- spindle synchronization signal disabled on pin 39. - activity LED signal available on pin 39. - Must be in place for CAM/ATA drives.
	X	- spindle synchronization signal enabled on pin 39. - activity LED signal disabled from pin 39.
		- pin 39 floating.

Jumper
E1	Disable Spin Up until command recieved
E2	Not used
E3	Not used

J6
1	+12V
2	Ground
3	Ground
4	+5V

J4
1	+5V
2	+12V
3	Ground

CMOS Drive Parameters
Cylinders	683
Heads	16
Sectors	38
Precomp	0
Landing Zone	683

Mounting Holes

Side: 6-32 UNC-2B .15 MAX. Insertion

Bottom: 6-32 UNC-2B .37MAX. Insertion