CP30200
SCSI Bus Address

There are three jumpers available for configuration. E1, E2 and E3 are used to select the drive SCSI ID. The following table defines the settings. Note: SCSI parity is always enabled. The following table defines the settings for jumpers E1, E2 and E3:

Jumper Options
E1	E2	E3	SCSI ID
OUT	OUT	OUT	O
IN	OUT	OUT	1
OUT	IN	OUT	2
IN	IN	OUT	3
OUT	OUT	IN	4
IN	OUT	IN	5
OUT	IN	IN	6
IN	IN	IN	7

Delay Spin: A jumper in the E4 location disables spin up on power-on. Disabling spin up on application of power can also be enabled by settting the DSPN bit in MODE SELECT page 0.

E4	DSPN	Result
IN	0	Spin Disabled
IN	1	Spin Disabled
OUT	0	Spin up on power on
OUT	1	Spin Disabled

J4
1	+12 V
2	Ground
3	Ground
4	+5V

Mounting Holes
Side: 6-32 UNC-2B .15 Max. Insertion
Bottom: 6-32 UNC-2B .25Max. Insertion