CP2124
Customer Options
The CP2124 drive is designed to operate either as a Master drive (C drive) or a Slave
drive (D drive). This feature is dependent on two drive settings; the status of hardware
Jumper M/S and the firmware setting of a feature bit. When (M/S) is closed, and the
feature bit is set, the drive will assume the role of a Master drive. When (M/S) is open,
and the feature bit reset, the drive will act as the Slave. In single drive
configurations, M/S must remain in the closed position.
| CMOS Drive Parameters |
| Cylinders |
762 |
| Heads |
8 |
| Sectors |
39 |
| Precomp |
0 |
| Landing Zone |
762 |
| Mounting Holes |
| Side: 3mmx0.5mm THD4x) 4mm Max. Insertion |
| Bottom: 3mmx0.5 THD (4x) 4mm Max. Insertion |
|
