CP2088
Customer Options

The CP2088 is designed to operate as a master (Drive C) or as a Slave (Drive D). This feature is dependent on two settings; Jumper E1 and the firmware setting of a feature bit. E1 closed and the feature bit is set, the drive will be the Master. E1 open the drive will be the Slave. As a single drive, E1 should be closed.

CMOS Drive Parameters
Cylinders	548
Heads	8
Sectors	38
Precomp	0
Landing Zone	548

Mounting Holes

Side: 3mm x 0.5mm THD (4x) 4mm Max. Insertion

Bottom: 3mm x 0.5mm THD (4x) 4mm Max. Insertion