CFA1080A
Customer Options
The C/D jumper is used to
determine whether the drive is a master (drive C) or a slave (drive D). The drive is
configured as a master, when jumpered, and a slave when not jumpered. The ATA/ISA jumper
is used when daisy-chaining two drives. This jumper may have to be removed when this drive
is used together with older (Pre-ATA) drives. The cable select (CS) jumper is used in
systems implementing cable select, in which master or slave is determined by the connector
attached to the task file interface.
| J6 |
J4 |
| 1 |
+12 V |
1 |
+5 V |
| 2 |
Ground |
2 |
+12V |
| 3 |
Ground |
3 |
Ground |
| 4 |
+5V |
| CMOS Drive Parameters |
| Cylinders |
2097* |
| Heads |
16 |
| Sectors |
63 |
| Precomp |
0 |
| Landing Zone |
2097 |
| Mounting
Holes |
| Side: 6-32
UNC-2B .16 Max. Insertion |
| Bottom:
6-32 UNC-2B .22 Max. Insertion |
* 1024 Cylinders should be
entered into the CMOS parameters unless the drive is being used with a device driver,
BIOS, or OS capable of supporting extended cylinders or LBA. |
