| |
Odd characters? Click here for help. A
version of this specification with the linedraw characters
approximated by text is available by clicking here.
SEAGATE TECHNOLOGY, INC.
1-800-SEAGATE
http://www.seagate.com
(C)opyright 1998
ST-33223A (Ultra ATA-3)
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º REAR VIEW º
ÈÍÍÍÍÍÍÍÍÍÍͼ
J2 40 pin I/O Cable Connection
³ pin-20 removed
³
ÕÍÍÍÍÍÍÍÍÍ ³ÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍ1Í/ÄÄÄÄÄÄÄÄÄ\ TOP (HDA)
͵::::::::::ú::::::::1³ : : : ³ 0 0 0 0 ³ÍÍ
ÔÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏͳͳͳÍÀÄ5ÄGÄGÄ12Ù BOTTOM
³ ³ ³
Master ON, Slave OFF ÄÙ ³ ³
Slave Present (when Master ON) ÄÄÄÄ´ ³
Cable Select (when Slave OFF) ÄÄÄÄÙ ³
Reserved ÄÄÄÄÄÄÙ
o o
1o o
³ ³
OFF - Full capacityÄÄÄÄ´ ³
(as shipped) ³ ³
ON - Limit capacityÄÄÄÄÙ ³
(to 2.1Gbytes, ³
4092 cylinders) ³
Reserved ÄÄÄÄÄÄÙ
Limit Capacity jumper sets the default cylinder translation
to 4092 to solve issues with certain BIOS that only auto-detect.
Total available sectors are still at full capacity as reported via
Identify Drive data words 52 - 61. Third party partitioning software
may be needed to achieve full capacity if this option jumper is used.
ST-33223A
FORMATTED CAPACITY (MB) __________________3,249
ACTUATOR TYPE ____________________________VOICE COIL
CYLINDERS __PHYSICAL______________________
HEADS ______PHYSICAL______________________3
DISCS (3.5 in) ___________________________2
MEDIA TYPE _______________________________THIN FILM
HEAD TYPE ________________________________MR
RECORDING METHOD _________________________PRML 16/17 (0,14) ZBR
INTERNAL TRANSFER RATE (Mbits/sec) _______up to 126
EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 33.3
PIO/DMA/UDMA MODE (max) __________________4/2/2
DMA SUPPORT ______________________________EISA Type B
SPINDLE SPEED (RPM) ______________________4500
AVERAGE LATENCY (mSEC) ___________________6.7
BUFFER ___________________________________128K
Read/Write Multiple, Read Look-Ahead,
Multi-Segmented
INTERFACE ________________________________Ultra ATA-3
SECTORS PER DRIVE (LBA mode) _____________6,346,368
TPI (TRACKS PER INCH) ____________________8,897
BPI (KBITS PER INCH) _____________________up to 165.0
AVERAGE ACCESS (ms seek/read/write) ______/11.0/13.0
SINGLE TRACK SEEK (ms seek/read/write) ___/1.5/3.0
MAX FULL SEEK (ms seek/read/write) _______/18.0/21.0
MTBF (power-on hours) Office _____________300,000
SHOCK (G's, 11ms/2ms):
operating (Read/Write) __________5
abnormal ________________________
nonoperating ____________________75/200
ACOUSTICS (bels) (typ/max) _______________3.7/4.5
POWER DISSIPATION (watts) ________________
POWER REQUIREMENTS: +12V START-UP (amps) _1.5
POWER MANAGEMENT (Watts):
ACTIVE _______________6.0
IDLE _________________3.3
STANDBY ______________0.8
WRITE PRECOMP (cyl) ______________________N/A
REDUCED WRITE CURRENT (cyl) ______________N/A
LANDING ZONE (cyl) _______________________AUTO
IBM AT DRIVE TYPE ________________________*
Physical:
Height (inches/mm): 1.03/26.1
Width (inches/mm): 4.02/102.1
Depth (inches/mm): 5.78/147.0
Weight (lb/g): 1.2/540
* MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO
SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE
AVAILABLE. (see below)
Possible translations:
This translation is generally acceptable, as
is, for non-DOS operating systems:
6,296 cyl, 16 heads, 63 sectors = 3,249,340,416
DOS operating systems may require a translation
that uses larger values for the CMOS head
parameter which lowers cylinders below 1024:
787 cyl, 128 heads, 63 sectors = 3,249,340,416
Other FULL-CAPACITY solutions for DOS operating
systems include third-party drive preparation
software, system BIOS which supports LBA mode
or bios driven host adapters. Otherwise,
capacity may be limited to:
1024 cyl, 16 heads, 63 sectors = 528,482,304
Some systems BIOS have capacity limitations.
Types that have been identified are:
a 2.113GB or 4095 cylinder limitation
DOS 16-bit FAT file system cannot access more than 2.147 Gbytes per
partition. FAT32 file system can create single partitions and
logical drives up to 2TB.
Note: A "custom" or "user-defined" CMOS drivetype may ask for a
numerical value for the Write Precompensation cylinder and for the
Landing Zone cylinder. A basic rule-of-thumb for drive models that do
not require the old Write Precomp technique or a Landing Zone because
they are Auto-Parking is to add 1 to the cylinder value being used. As
an example: If cylinders equaled 820, then both Write Precomp and
Landing Zone would be entered as 821. Some BIOS will convert this to
65535 or -1, which are functionally equivalent to "none (not used)".
Already low-level formatted at the factory.
Since a User-definable or Custom translation geometry may be used, it
is imperative that the values be written down and kept with your
permanent records for retrieval in the event of CMOS battery failure.
Seagate reserves the right to change, without notice, product
offerings or specifications. (11/08/98)
A copy of this specification file may be obtained
by FTP at
ftp://ftp.seagate.com/techsuppt/at/ST33223A.TXT.
 |
|