| |
Odd characters? Click here for help. A
version of this specification with the linedraw characters
approximated by text is available by clicking here.
SEAGATE TECHNOLOGY LLC
1-800-SEAGATE
http://www.seagate.com
(C)opyright 2002
ST-315313A (Barracuda ATA IV 15313, Ultra ATA/100)
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º REAR VIEW º
ÈÍÍÍÍÍÍÍÍÍÍͼ
J2 40 pin I/O Cable Connection
³ pin-20 removed
³
³ ÚÄÄ [spare jumper on pins 5-7]
³ ³
ÕÍÍÍÍÍÍÍÍÍ ³ÍÍÍÍÍÍÍÍÍÑÍͳÍÍÍÍ1Í/ÄÄÄÄÄÄÄÄÄ\ TOP (HDA)
͵::::::::::ú::::::::1³ :Á: : : ³ 0 0 0 0 ³ÍÍ
ÔÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏ8³Í³Í³Í³ÍÀÄ5ÄGÄGÄ12Ù BOTTOM
³ ³ ³ ³
³ ³ ³ ÀÄÄ Limit Capacity (see below)
³ ³ ÀÄÄÄÄ Reserved
O=OFF, X=ON -->> X-OÄÄÄÄÄÄ Master ON
O-OÄÄÄÄÄÄ Slave OFF
X-XÄÄÄÄÄÄ Slave Present (when pins 7-8 ON
used on Master drive)
O-XÄÄÄÄÄÄ Cable Select (when pins 7-8 OFF)
Limit Capacity jumper sets the default cylinder translation
to 4092 to solve issues with certain BIOS that only auto-detect.
Total available sectors are still at full capacity as reported via
Identify Drive data words 52 - 61. Third party partitioning software
may be needed to achieve full capacity if this option jumper is used.
ST-315313A
Barracuda ATA IV
FORMATTED CAPACITY (GB) __________________15.3
ACTUATOR TYPE ____________________________VOICE COIL
CYLINDERS __PHYSICAL______________________
HEADS ______PHYSICAL______________________1
DISCS (3.5 in) ___________________________1
MEDIA TYPE _______________________________THIN FILM
HEAD TYPE ________________________________GMR
RECORDING METHOD _________________________EPRML 16/17 ZBR
INTERNAL TRANSFER RATE (Mbits/sec) _______up to 555
EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 100
PIO/DMA/UDMA MODE (max) __________________4/2/5
DMA SUPPORT ______________________________EISA Type B
SPINDLE SPEED (RPM) ______________________7200
AVERAGE LATENCY (mSEC) ___________________4.16
BUFFER ___________________________________2MB
Read/Write Multiple, Read Look-Ahead,
Multi-Segmented
INTERFACE ________________________________Ultra ATA/100
SECTORS PER DRIVE (LBA mode) _____________29,888,820
TPI (TRACKS PER INCH) ____________________58,000
BPI (KBITS PER INCH) _____________________up to 540,000
AVERAGE ACCESS (ms seek/read/write) ______9.0/9.0/10.0
SINGLE TRACK SEEK (ms seek/read/write) ___/0.95/0.76
MAX FULL SEEK (ms seek/read/write) _______//
MTBF (power-on hours) Office _____________600,000
SHOCK (G's, 11ms/2ms):
operating (Read/Write) __________/63
abnormal ________________________
nonoperating ____________________/350
ACOUSTICS (bels)
fluid bearing (typ/max) _________2.3/3.4
POWER DISSIPATION (watts) ________________
POWER REQUIREMENTS: +12V START-UP (amps) _2.8
POWER MANAGEMENT (Watts):
ACTIVE _______________13.0
IDLE _________________9.8
STANDBY (typ/max) ____1.15/1.3
Physical:
Height (inches/mm): 1.028/26.1
Width (inches/mm): 4.02/101.8
Depth (inches/mm): 5.75/147.0
Weight (lb/g): 1.2/544
Set CMOS hard drive setup to Auto-Detect with LBA mode enabled.
Some systems BIOS have capacity limitations.
Types that have been identified are:
a 2.113GB or 4095 cylinder limitation
a 3.262GB or 6322 cylinder limitation
a 4.22GB or 8192 cylinder limitation
a 8.45GB Standard INT13 limitation (CHS[1024x256x63]x512)
a 33.8GB or 66,060,287 LBAs limitation
and, if exceeded, may cause the system to hang during boot,
capacity reduction or it can truncate or wrap the cylinders when
auto-detect options set in the CMOS. FAT16 based operating systems
are also limited to 8.4GB. New INT13 Extensions in BIOS and FAT32
based operating systems are both required to acheive full capacity.
DOS 16-bit FAT file system cannot access more than 2.147 Gbytes per
partition. FAT32 file system can create single partitions and
logical drives up to 2TB.
Already low-level formatted at the factory.
Seagate reserves the right to change, without notice, product
offerings or specifications. (12/04/2002)
A copy of this specification file may be obtained
by FTP at
ftp://ftp.seagate.com/techsuppt/at/ST315313.A.
 |
|