| |
Odd characters? Click here for help. A
version of this specification with the linedraw characters
approximated by text is available by clicking here.
SEAGATE TECHNOLOGY, INC.
1-800-SEAGATE
http://www.seagate.com
(C)opyright 2000
ST-310212A (U10 10212, Ultra ATA/66)
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º REAR VIEW º
ÈÍÍÍÍÍÍÍÍÍÍͼ
J2 40 pin I/O Cable Connection
³ pin-20 removed
³
ÕÍÍÍÍÍÍÍÍÍ ³ÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍ1Í/ÄÄÄÄÄÄÄÄÄ\ TOP (HDA)
͵::::::::::ú::::::::1³ : : : : ³ 0 0 0 0 ³ÍÍ
ÔÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏ8³Í³Í³Í³ÍÀÄ5ÄGÄGÄ12Ù BOTTOM
³ ³ ³ ³
Master ON, Slave OFF ÄÄÙ ³ ³ ³
Slave Present (when Master ON) ÄÄÄÄ´ ³ ³
Cable Select (when Slave OFF) ÄÄÄÄÙ ³ ³
Reserved ÄÄÄÄÄÄÙ ³
Reserved ÄÄÄÄÄÄÄÄÙ
ST-310212A
FORMATTED CAPACITY (MB) __________________10,242
ACTUATOR TYPE ____________________________VOICE COIL
CYLINDERS __PHYSICAL______________________
HEADS ______PHYSICAL______________________2
DISCS (3.5 in) ___________________________1
MEDIA TYPE _______________________________THIN FILM
HEAD TYPE ________________________________GMR
RECORDING METHOD _________________________EPRML 24/26 ZBR
INTERNAL TRANSFER RATE (Mbits/sec) _______up to 308
EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 66.6
PIO/DMA/UDMA MODE (max) __________________4/2/4
DMA SUPPORT ______________________________EISA Type B
SPINDLE SPEED (RPM) ______________________5400
AVERAGE LATENCY (mSEC) ___________________5.56
BUFFER ___________________________________512K
Read/Write Multiple, Read Look-Ahead,
Multi-Segmented
INTERFACE ________________________________Ultra ATA/66
SECTORS PER DRIVE (LBA mode) _____________20,005,650
TPI (TRACKS PER INCH) ____________________20,107
BPI (BITS PER INCH) ______________________396,067
AVERAGE ACCESS (ms seek/read/write) ______8.9/10.5/11.5
SINGLE TRACK SEEK (ms seek/read/write) ___/1.5/2.1
MAX FULL SEEK (ms seek/read/write) _______/23.0/25.0
MTBF (power-on hours) Office _____________500,000
SHOCK (G's, 11ms/2ms):
operating (Read/Write) __________/63
abnormal ________________________
nonoperating ____________________/350
ACOUSTICS (bels) (typ/max) _______________3.2/3.9
POWER DISSIPATION (watts) ________________
POWER REQUIREMENTS: +12V START-UP (amps) _1.5
POWER MANAGEMENT (Watts):
ACTIVE _______________7.0
IDLE _________________3.5
STANDBY ______________0.8
WRITE PRECOMP (cyl) ______________________N/A
REDUCED WRITE CURRENT (cyl) ______________N/A
LANDING ZONE (cyl) _______________________AUTO
IBM AT DRIVE TYPE ________________________*
Physical:
Height (inches/mm): 1.03/26.1
Width (inches/mm): 4.00/101.85
Depth (inches/mm): 5.78/147.0
Weight (lb/g): 1.2/544
* Set CMOS hard drive setup to Auto-Detect with LBA mode enabled.
* MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO
SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE
AVAILABLE. (see below)
Possible translations:
This translation is generally acceptable, as
is, for non-DOS operating systems:
16,383 cyl, 16 heads, 63 sectors = 8,455,200,780
DOS operating systems may require a translation
that uses larger values for the CMOS head
parameter which lowers cylinders below 1024:
1023 cyl, 256 heads, 63 sectors = 8,447,459,328
Other FULL-CAPACITY solutions for DOS operating
systems include third-party drive preparation
software, system BIOS which supports LBA mode
or bios driven host adapters. Otherwise,
capacity may be limited to:
1024 cyl, 16 heads, 63 sectors = 528,482,304
Some systems BIOS have capacity limitations.
Types that have been identified are:
a 2.113GB or 4095 cylinder limitation
a 3.262GB or 6322 cylinder limitation
a 4.22GB or 8192 cylinder limitation
a 8.45GB Standard INT13 limitation (CHS[1024x256x63]x512)
and, if exceeded, may cause the system to hang during boot,
capacity reduction or it can truncate or wrap the cylinders when
auto-detect options set in the CMOS. FAT16 based operating systems
are also limited to 8.4GB. New INT13 Extensions in BIOS and FAT32
based operating systems are both required to acheive full capacity.
DOS 16-bit FAT file system cannot access more than 2.147 Gbytes per
partition. FAT32 file system can create single partitions and
logical drives up to 2TB.
Already low-level formatted at the factory.
Seagate reserves the right to change, without notice, product
offerings or specifications. (01/20/2000)
A copy of this specification file may be obtained
by FTP at
ftp://ftp.seagate.com/techsuppt/at/ST310212.A.
 |
|